70-1488W DOWNLOAD

The 6 digit of the model number sets the control head type. Click the Next button to continue to the Channel Data screen. The program will then switch to the Select Radio Model screen. Enter the appropriate receive and transmit channel frequencies and signaling data in the appropriate boxes. As a minimum, a receive channel frequency must be entered for at least one channel on the Channel Data screen and the channel must be entered in a Channel List from the Select Detailed Group Part 3 of 3 screen. Channel in Scan Group B? Turn the radio on.

Uploader:	Togore
Date Added:	16 January 2012
File Size:	17.22 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	73289
Price:	Free* [*Free Regsitration Required]

The program will then switch to the Select Radio Model screen. This will open the test screen.

Scan Hold ConditionsSelect the condition that will cause scan to stop on a channel from the Scan Hold Conditions drop box. Click the Next or Finish button to continue to the Finish screen. This will open the Load Radio File dialog box. The 6 70--1488w of the model number sets the control head type.

Subsignaling TypeSelect Type or for installed options. Click the Next button to continue to the Select Radio Model screen. The Priority 1 channel is the selected channel when scan was activated. The Priority 1 channel is the displayed channel while scanning and may be changed using the UP and DN buttons.

When the programming is finished turn the radio off and then unplug the programming cable. Click the Next button to continue to the Channel Data screen.

OptionsTo set the communications port to which the A is attached click the Options button. If Low Only is selected the radio will always transmit at the low power setting. Choose No Clear to never restore deleted channels to the scan list.

70 1488W CD STII XTRProgSoftwareUsersManual

Priority 2 channel sampling will occur at half this rate. When an 8 channel mobile is programmed for Modified scan, operation is the same as Normal scanMidland Radio Corporation 7 type.

Identify Radio FeaturesThe Identify Radio Features screen allows changing the injection aspect 770-1488w an injection kit has been installedchanging the PLL reference frequency and inputting an optional serial number, customer name and date.

The Priority 1 and Priority 2 if assigned will be sampled and the radio will transmit on the priority channel during scan hold time.

Follow the instructions on the screen to install the software. The Priority 1 channel will be the channel selected when scan was activated and the radio will always transmit on the Priority 1 channel.

Choose Special to inhibit transmission when carrier is present 70-488w the programmed signaling is not present. On these B-MM models, failure to check the boxes correctly will result in incorrect PLL data calculations and synthesizer out of lock errors.

Select Radio ModelHighlight the band of the radio to be programmed from the list and click the Next button to continue to the Identify Radio Features screen. Priority Ch Monitor TimeSelect the priority channel sampling rate while scan is stopped on a non-priority channel in the Priority Ch Monitor Time drop box.

If Normal is sele The scrambler is an option that is usually enabled by a front panel button; this check box enables scrambler operation on the channel being edited.

Select a model type from the list and click the Next button. Transmit will always occur on the Priority 1 channel. Refer to the option instructions for programming these bits.

Installation and Setup Tips for Midland W-CD Windows Programming Software

The Priority 1 channel is retained in memory and becomes active when ESC is pressed again. Auxiliary DataThis data is used to control some options.

Press the Next button to continue to the Channel Data screen. If AutoOpen is not enabled, from 07-1488w start menu select Run and type D: Once the model number 70-14488w entered click the Next button to continue to the Identify Radio Features screen.

Enter the appropriate receive and transmit channel frequencies and signaling data in the appropriate boxes. Activating the P MON mode allows the user to transmit and receive on the displayed channel the secondary channel while sampling the Priority 1 and Priority 2 if assigned channel.